Express 1500 AWD V8-5.3L (2008)
4. While supporting the adjustment arm, slide the torsion bar rearward until the torsion bar fully engages the adjustment arm.
5. Install the J 36202 to the adjustment arm and the support.
6. Increase the tension on the adjustment arm in order to load the torsion bar.
Important: Install the adjustment bolt the same amount of turns that were required to remove the bolt during removal.
7. Install the adjustment bolt and the adjuster nut.
8. Remove the J 36202 releasing the tension on the torsion bar until the load is taken up by the adjustment bolt.
9. Lower the vehicle.
10. Measure the Z height. Refer to Trim Height Inspection (See: Testing and Inspection/Component Tests and General Diagnostics/Trim Height
Inspection) .
11. Turn the adjustment bolt clockwise to increase the Z height and counterclockwise to decrease the Z height.