Express 1500 AWD V8-5.3L (2008)
8. Insert a flat-tipped screw driver or small pry bar in the space between the outer race of the seal and the transfer case.
9. Pry the outer race out of the transfer case.
10. Remove the outer part of the seal.
Installation Procedure
1. Using the J 43484 (2) and the J 8092 (1), install the transfer case output seal.
2. Install the front propeller shaft. Refer to Front Propeller Shaft Replacement (See: Drive/Propeller Shafts, Bearings and Joints/Drive/Propeller
Shaft/Service and Repair/Front Propeller Shaft Replacement) .
3. Check the transfer case fluid level. Refer to Transfer Case Fluid Replacement (See: Service and Repair/Removal and Replacement/Transfer Case
Fluid Replacement) .
4. Lower the vehicle. Refer to Lifting and Jacking the Vehicle .
