Express 1500 AWD V8-5.3L VIN T (2004)
8. Measure the torque required in order to rotate the pinion. Use an inch-pound torque wrench. Record the torque value for reassembly. This will
give the combined preload for the following components:
^
The pinion bearings
^
The pinion seal
^
The carrier bearings
^
The axle bearings
^
The axle seals
9. Scribe an alignment line between the pinion shaft and the pinion yoke.
10. Install the J8614-01 onto the pinion yoke as shown.
11. Remove the pinion nut while holding the J8614-01.
