Express 1500 AWD V8-5.3L VIN T (2004)
12. Install the J8614-2 (2) and the J8614-3 11) into the J8614-01 (3) as shown.
13. Remove the pinion yoke by turning the J8614-3 (1) clockwise while holding the J8614-01 (3).
Important: Carefully pry the seal from the bore.
Do not distort or scratch the aluminum case.
14. Remove the oil seal using a suitable seal removal tool.
Installation Procedure
1. Install the oil seal by doing the following:
1.1.
Position the oil seal in the bore.
1.2.
Install the J33782 over the oil seal.
1.3.
Strike the J33782 with a hammer until the seal flange seats on the axle housing surface.
2. Apply sealant GM P/N 12346004 (Canadian P/N 10953480) or equivalent to the splines of the drive pinion yoke.
3. Install the pinion yoke.
Align the reference marks made during removal.
Notice: Refer to Pinion Flange/Yoke Installation Notice in Service Precautions.
4. Seat the pinion flange onto the pinion shaft by tapping it with a soft-faced hammer until a few pinion shaft threads show through the flange.
5. Install the washer.
