Express 1500 RWD V6-4.3L (2007)
20. Route the deployment harness out of the vehicle's driver side.
21. Disconnect the inflatable restraint I/P module connector (1) located under the instrument panel extension (3).
Important: This vehicle is equipped with dual stage air bags. The steering wheel module and I/P module will each have 4 wires. Refer to
SIR Connector End Views for determining high and low circuits.
22. Cut the I/P module harness connector out of the vehicle, leaving at least 16 cm (6 in) of wire at the connector.
23. Strip 13 mm (0.5 in) of insulation from each of the connector wire leads.
24. Cut two 6.1 m (20 ft) deployment wires from a 0.8 mm (18 gage) or thicker multi-strand wire. These wires will be used to fabricate the
deployment harness.
25. Strip 13 mm (0.5 in) of insulation from both ends of the wires cut in the previous step.
26. Twist together one end from each of the wires in order to short the wires.
