chevrolet Workshop Repair Guides

Chevrolet Workshop Service and Repair Manuals

Deployment Outside Vehicle - I/P Module and Steering Wheel Module|Page 11117 > < Deployment Outside Vehicle - I/P Module and Steering Wheel Module|Page 11115
Page 6
background image

45. Move the power source, 12 V minimum/2 A minimum, i.e., a vehicle battery, near the shorted ends of the driver side deployment harnesses.
46. Separate the ends of the steering wheel module deployment harness wires.
47. Connect the steering wheel module deployment harness wires to the power source in order to deploy the steering wheel module.
48. Disconnect the steering wheel module deployment harness wires from the power source.

49. Twist together one end of each wire of the steering wheel module on the driver side deployment harness in order to short the wires.
50. Remove the drop cloth from the vehicle.
51. Disconnect all harnesses from the vehicle.
52. Discard the harnesses.
53. Scrap the vehicle in the same manner as a non-SIR equipped vehicle.
54. If one or more of the inflator modules did not deploy, perform the following steps to remove the undeployed modules from the vehicle:

-

Inflatable Restraint Steering Wheel Module Replacement

-

Inflatable Restraint Instrument Panel Module Replacement

55. Contact the Technical Assistance Group for further assistance.

Deployment Outside Vehicle - I/P Module and Steering Wheel Module|Page 11117 > < Deployment Outside Vehicle - I/P Module and Steering Wheel Module|Page 11115