Express 1500 RWD V6-4.3L VIN X (2005)
9. When deploying an I/P module, refer to the following instructions:
-
Place the J 39401-B (2) in the center of the cleared area.
-
Fill the deployment fixture (2) with water or sand.
-
Mount the I/P module (1) in the deployment fixture (2) with the vinyl/plastic trim facing up.
-
To mount, use 4 M 6 bolts (6), nuts (8), and washers (7) to properly secure the I/P module (1) to the deployment fixture (2).
-
Tighten all fasteners prior to deployment.
10. Inspect the J 38826 and the appropriate pigtail adapter for damage. Replace as needed.
11. Short the 2 SIR deployment harness leads (1) together using one banana plug seated into the other.
12. Connect the appropriate pigtail adapter (2) to the SIR deployment harness (1).
13. Extend the SIR deployment harness and adapter to full length from the deployment fixture.
14. Connect the inflator module (1) to the adapter (2) on the SIR deployment harness (3).
15. Clear the area of people.
IMPORTANT:
-
The rapid expansion of gas involved with deploying an inflator module is very loud. Notify all people in the immediate area that an inflator
module will be deployed.
-
When the inflator module deploys, the deployment fixture may jump vertically. This is a normal reaction of the inflator module due to the force of
the rapid expansion of gas inside the inflator module.
