Express 1500 RWD V6-4.3L VIN X (2005)
1. Clean all grease and contaminants from the tapered section and the threads of the upper ball joint, the lower ball joint, and the tie rod end.
2. Clean and inspect the taper holes and the mounting surfaces of the steering knuckle. If any of the tapered holes are elongated, out of round, or
damaged. the replace the steering knuckle.
3. Install the steering knuckle.
Notice: Refer to Fastener Notice in Service Precautions.
4. Install the lower ball joint to steering knuckle retaining nut.
-
Tighten the retaining nut to 100 Nm (74 ft. lbs.).
5. Install the upper ball joint to steering knuckle retaining nut.
-
Tighten the retaining nut to 50 Nm (37 ft. lbs.).