Express 1500 RWD V6-4.3L VIN X (2005)
Heated Glass Element: Component Tests and General Diagnostics
DEFOGGER GRID LINES DIAGNOSIS
1. Start the engine.
2. Turn the rear window defogger ON.
3. Connect a test lamp to a good ground.
4. Move the test lamp probe from zone 5 to zone 1 along each grid line.
-
If the test lamp does not illuminate anywhere on the grid, the problem may be in the circuit. Refer to Defogger Inoperative - Rear Window.
See: Symptom Related Diagnostic Procedures/Defogger Inoperative - Rear Window
-
If the test lamp shows full brilliance at both ends of the grid lines, inspect for an open or poor connection in the ground circuit of the rear
window defogger grid.
-
If the test lamp goes out, locate the open in that grid line. Test every grid line in at least 2 places (1, 3) to eliminate the possibility of bridging
an open (2) in the grid line.
IMPORTANT: The test lamp brilliance will decrease proportionately to the increased resistance in the grid line as the probe is moved from the
battery positive bus wire to the ground bus wire. The test lamp brilliance may vary from one window to another.
5. If an open is located, replace the rear window.
