Express 1500 RWD V8-5.3L (2008)
8. Remove the bolts from the EBCM (2).
Important: Do not use a tool to pry the EBCM or the BPMV. Excessive force will damage the EBCM.
9. Remove the EBCM (2) from the BPMV (1). Removal may require a light amount of force.
10. Clean the EBCM to BPMV mounting surfaces with a clean cloth.
Installation Procedure
Important: Do not use RTV or any other type of sealant on the EBCM gasket or mating surfaces.
1. Install the EBCM (2) onto BPMV (1).
Notice: Refer to Fastener Notice .
Important: Do not reuse the old mounting bolts. Always install new EBCM bolts with the new BPMV.
2. Install the EBCM bolts.
Tighten the bolts to 5 N.m (44 lb in) in an X-pattern.
3. Connect the 2-way ABS pump motor connector to the EBCM.
4. Install the BPMV (1) to EHCU bracket (3).
5. Install the BPMV (1) to bracket retaining bolts (4).
Tighten the bolts to 9 N.m (80 lb in).
