Express 1500 RWD V8-5.3L (2008)
Hydraulic Fluid Accumulator: Service and Repair
Hydraulic Brake Booster Accumulator Replacement
Tools Required
J 26889 Accumulator Piston Compressor
Removal Procedure
Caution: The accumulator contains compressed gas. Always use the proper tools and follow the recommended procedures or personal injury may result.
Do not apply heat to accumulator. Do not attempt to repair an inoperative accumulator. Always replace an inoperative accumulator with a new one.
Dispose of an inoperative accumulator by drilling a 1.5 mm (1/16 in) diameter hole through the end of the accumulator can, opposite the O-ring.
Caution: Push rod removal is not recommended. Improper staking of the push rod to the Hydroboost reaction piston can result in a loss of brakes. If the
rod or seals require service, the entire unit must be replaced.
1. Depress brake pedal at least ten times to relieve pressure in the accumulator.
2. Remove the master cylinder from the hydraulic booster. Do not remove the brake pipes. Set the master cylinder aside in the engine compartment.
