Express 1500 RWD V8-5.3L (2008)
1. Position the fuel feed and EVAP pipes in the vehicle.
Notice: Refer to Fastener Notice.
2. Install the fuel pipe retaining clips.
Tighten the clips to 12 N.m (106 lb in).
3. Connect the chassis EVAP pipe to the fuel tank EVAP pipe.
4. Connect the fuel feed pipe to the fuel tank pipe.
5. Connect the chassis wiring harness electrical connector (1) to the fuel pressure sensor (2).
6. Install the chassis wiring harness clip (3) to the fuel pipe.
7. Lower the vehicle.
8. Install the fuel feed and EVAP pipes to the engine compartment fuel pipes.
9. Install the fuel pipes to the retainer clip.
Tighten the nut to 28 N.m (21 lb ft).
10. Tighten the fuel filler cap.
11. Connect the negative battery cable. Battery Negative Cable Disconnection and Connection.
12. Inspect for leaks:
