Express 1500 RWD V8-5.3L (2008)
6. Remove the fuel pipes from the bellhousing stud retainer clip.
7. Raise the vehicle. Refer to Vehicle Lifting.
8. Disconnect the fuel feed pipe at the fuel tank.
9. Disconnect the chassis EVAP pipe from the fuel tank.
10. Remove the fuel pipe retaining clips. Note the location of the retaining clips for installation.
11. Remove the fuel feed and EVAP pipes.
Installation Procedure
1. Position the fuel feed and EVAP pipes in the vehicle.
Notice: Refer to Fastener Notice.
2. Install the fuel pipe retaining clips.
Tighten the clips to 12 N.m (106 lb in).
3. Connect the chassis EVAP pipe to the fuel tank EVAP pipe.
4. Connect the fuel feed pipe to the fuel tank pipe.