Express 1500 RWD V8-5.3L (2008)
5. Connect the chassis wiring harness electrical connector (1) to the fuel pressure sensor (2).
6. Install the chassis wiring harness clip (3) to the fuel pipe.
7. Lower the vehicle.
8. Install the fuel feed and EVAP pipes to the engine compartment fuel pipes.
9. Install the fuel pipes to the retainer clip.
Tighten the nut to 28 N.m (21 lb ft).
10. Tighten the fuel filler cap.
11. Connect the negative battery cable. Battery Negative Cable Disconnection and Connection.
12. Inspect for leaks:
1. Turn ON the ignition for 2 seconds.
2. Turn OFF the ignition for 10 seconds.
3. Turn ON the ignition.
4. Inspect for fuel leaks.
13. Install the engine cover.
Fuel Hose/Pipes Replacement - Chassis (Cutaway Van - Rear Tank)
Fuel Hose/Pipes Replacement - Chassis (Cutaway Van - Rear Tank)
Removal Procedure
Caution: Refer to Battery Disconnect Caution.
1. Disconnect the negative battery cable.
2. Relieve the fuel system pressure. Refer to Fuel Pressure Relief (With CH 48027) Fuel Pressure Relief (Without CH 48027).
3. Drain the fuel tank. Refer to Fuel Tank Draining.
4. Raise the vehicle. Refer to Vehicle Lifting.
