Express 1500 RWD V8-5.3L (2008)
5. Install the SDM (2) electrical connector.
6. Install the CPA to the SDM electrical connector.
7. Install the carpet to cover SDM (2).
8. Install the driver seat.
Important: The AIR BAG indicator may remain ON after the SDM has been replaced. DTC B1001 may set requiring the SDM part
number to be set in multiple modules. If the indicator remains ON after enabling the SIR system, perform the diagnostic system check
and follow the steps thoroughly to ensure that the SDM is set properly.
9. Enable the SIR system. Refer to SIR Disabling and Enabling.
10. Refer to Programming and Relearning. See: Testing and Inspection/Programming and Relearning
