Express 1500 RWD V8-5.3L (2008)
6. Remove the power brake booster inlet hose (1) from the power brake booster (2).
7. Remove the power brake booster inlet hose from the vehicle.
Installation Procedure
Notice: Refer to Installing Hoses Without Twists or Bends Notice .
1. Route the hose in the same position the hose occupied prior to removal.
Notice: Refer to Fastener Notice .
2. Install the power brake booster inlet hose (1) to the power brake booster (2). Hand tighten.
3. Raise the vehicle.
4. Install the power brake booster inlet hose (2) to the power steering pump (1) through the wheel well.
Tighten the hose fitting to 33 N.m (24 lb ft).
5. Lower the vehicle.
6. Tighten the power brake booster inlet hose to the power brake booster.
Tighten the hose fitting to 33 N.m (24 lb ft).
7. Bleed the power steering system. Refer to Power Steering System Bleeding (See: Power Steering Bleeding/Service and Repair) .
8. Remove the drain pan from under the vehicle.
