Express 1500 RWD V8-5.3L (2008)
1. Clean all corrosion or contaminates from the steering knuckle bore and the hub and bearing.
2. Lubricate the steering knuckle bore with wheel bearing grease or the equivalent.
3. Install the wheel hub and bearing and splash shield to the steering knuckle.
Notice: Refer to Fastener Notice .
4. Install the wheel hub and bearing mounting bolts.
Tighten the bolts to 180 N.m (133 lb ft).
5. Install the wheel speed sensor to the wheel hub and bearing.
6. Install the wheel speed sensor retaining bolt.
Tighten the bolt to 18 N.m (13 lb ft).
7. Install the rotor. Refer to Front Brake Rotor Replacement .
8. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation (See: Maintenance/Wheels and Tires/Service and Repair) .
9. Lower the vehicle.