Express 1500 RWD V8-5.3L VIN T (2004)
1. Install the cable to the vehicle.
2. Install the park brake cable (2) to the lever (1).
3. Perform the following procedure to install the cable (2) to the backing plate (4).
1. Compress the spring (3) by pushing toward the lever (1).
2. Route the cable (2) through the slot in the backing plate.
3. Push the cable housing into the backing plate (4) until the locking tabs snap into place.
4. Notice:
Refer to Fastener Notice in Service Precautions.
Install the bolt retaining the cable to the lower shock mount.
^
Tighten the bolt to 13 Nm (115 inch lbs.).