Express 1500 RWD V8-5.3L VIN T (2004)
1. Important: Do not apply force to the sensor (1) or the bearing adapter (3) in a sideways direction.
If reusing the sensor, with the pin still installed, align the sensor onto the steering shaft (2) and into the bearing adapter (3).
2. Important: If installing a new sensor the sensor will come precentered. Do not remove the pin until installation is complete.
Install the sensor onto the steering shaft (2) and into the bearing adapter (3).
3. The sensor must be set to approximately 3.00 mm gap between the sensor and the bearing adapter.
4. Install the sensor connector.
5. Remove the pin from the sensor.Install the sensor retainer onto the steering shaft.
6. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners
requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use
paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint
clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid
damage to parts and systems.
Slide the shaft up to install the bolt and the nut to the upper intermediate shaft to steering column connection.
-
Tighten the upper intermediate shaft connection to 47 Nm (35 ft. lbs.).
7. For vehicles with Rear Wheel Steering, check the wheel alignment.
8. Install the steering column from the vehicle.
9. Enable the SIR system.
