Express 1500 RWD V8-5.3L VIN T (2004)
4. Disconnect the electrical connectors from the EBCM.
5. Remove the mounting screws that fasten the EBCM (2) to the BPMV (1).
6. Remove the EBCM (2) from the BPMV (1). Removal may require a light amount of force.
7. Clean the BPMV to EBCM mounting surfaces with a clean cloth.
Installation Procedure
1. Important:
Do not use RTV or any other type of sealant on the EBCM gasket or mating surfaces.
Install the EBCM (2) on to the BPMV (1).
2. Notice:
Refer to Fastener Notice in Service Precautions.
Install the screws to the EBCM (2).
^
Tighten the screws to 5 Nm (44 inch lbs.) in an X-pattern.
