Express 1500 RWD V8-5.3L VIN T (2004)
7. Important: Perform the following procedures when removing the retaining ring and cooler line from the quick connect fitting on the
transmission.
Pull the plastic cap back from the quick connect fitting and down along the cooler line about two inches.
8. Using a bento tip screwdriver, pull on one of the open ends of the retaining ring in order to rotate the retaining ring around the quick connect
fitting until the retaining ring is out of position and can be completely removed.
9. Remove the retaining ring from the quick connect fitting.
10. Discard the retaining ring.
11. Pull the cooler line straight out from the quick connect fitting.
12. Remove the retaining ring (E-clips) securing the cooler line to the quick connect in order to remove the remaining cooler lines from the remaining
quick connect fittings.
13. Remove the cooler lines from the vehicle.
14. Lower the vehicle.
