Express 1 Ton Van V8-5.7L VIN R (1999)
5. Connect the by-pass hose to the thermostat housing crossover.
6. Connect the heater hose to the thermostat housing crossover.
7. Connect the electrical connector to the coolant temperature sensor.
8. Install the A/C compressor.
9. Install the stud in order to secure the fuel bleed valve at the thermostat housing.
10. Install the nut in order to secure the dipstick tubes at the thermostat housing.
11. Connect the battery negative cable to the auxiliary battery terminal.
12. Connect the battery negative cable to the battery terminal.
13. Refill the engine cooling system.
14. Bleed the air from the engine cooling system by the following:
14.1. Remove the cap from the surge tank.
14.2. Remove the bleed screw (slotted) from the top of the thermostat housing.
14.3. Pour anti-freeze into the surge tank, and watch for a of anti-freeze from the bleed screw.
14.4. When a constant flow of anti-freeze is reached, closed the bleed screw at the top of the thermostat housing.
