Express 1 Ton Van V8-6.5L DSL Turbo VIN F (1998)
Crankshaft Main Bearing Seal: Service and Repair
REMOVAL PROCEDURE
^
Tools Required
-
J 39084 Rear Crankshaft Oil Seal Installer
1. Open the hood.
IMPORTANT: Before a new seal is installed, the CDR and the crankcase ventilation system should be thoroughly inspected and the crankcase
pressure should also be checked.
2. Disconnect the battery negative cables from the batteries.
3. Remove the transmission from the vehicle.
4. Remove the flywheel from the crankshaft.
5. Remove the crankshaft rear oil seal from the engine block.
INSTALLATION PROCEDURE
^
Tools Required
-
J 39084 Rear Crankshaft Oil Seal Installer
1. Install the crankshaft rear oil seal into the tool, with the spring cavity towards the engine, onto the crankshaft.
IMPORTANT: Coat the crankshaft surface with clean engine oil, and lightly coat the sealing area of the new oil seal with engine oil or grease
before installing the new oil seal. Do not scratch or nick the sealing edge of the oil seal.
2. Use the J 39084, to install the crankshaft rear oil seal in the engine block.
3. Install the flywheel on to the crankshaft. Refer to Engine Flywheel Installation under Engine Unit Repair.
4. Install the transmission in the vehicle.
