Express 2500 V8-4.8L (2007)
9. Remove the screws (2) from the evaporator and blower module assembly.
10. Remove the evaporator and blower module assembly front cover (3).
11. Remove the recirculation door actuator (7) and the linkage.
Installation Procedure
1. Install the recirculation door actuator (7) and the linkage.
2. Install the evaporator and blower module assembly cover (3).
Notice: Refer to Fastener Notice.
3. Install the screws.
Tighten the screws to 1.9 N.m (17 lb in).
4. Install new sealing washers to the evaporator inlet and outlet tubes.
5. Install the evaporator inlet tube (4) to the evaporator (5).
6. Install the evaporator inlet tube retaining nut (3).
Tighten the nut to 16 N.m (12 lb ft).
7. Install the evaporator outlet hose and retaining nuts (4,5).
Tighten the nut to 18 N.m (13 lb ft).
