Express 2500 V8-4.8L (2007)
Stabilizer Bushing: Service and Repair
Front Suspension
Stabilizer Shaft Insulator Replacement
Removal Procedure
1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
2. Remove the stabilizer shaft insulator clamps mounting bolts (4) (1500 and 2500 series w/7300 GVW).
3. Remove the stabilizer shaft insulator clamps (3) from the stabilizer shaft insulator (2) (1500 and 2500 series w/7300 GVW).
4. Lower the stabilizer shaft (5) and remove the stabilizer shaft insulator (2) (1500 and 2500 series w/7300 GVW).
Important: The stabilizer shaft insulator stud may come out of the frame when removing stabilizer shaft insulator mounting nuts.
5. Remove the stabilizer shaft insulator clamps nuts (3) and/or studs (2500 series w/8500 and 8600 GVW and 3500 series).
6. Remove the stabilizer shaft clamps (4) (2500 series w/8500 and 8600 GVW and 3500 series).
7. Lower the stabilizer shaft (2) and remove the stabilizer shaft insulators (5) (2500 series w/8500 and 8600 GVW and 3500 series).
8. Inspect all of the parts for wear and damage.
Installation Procedure
Notice: Refer to Fastener Notice .
1. Install the stabilizer shaft insulator clamp studs, if removed (2500 series w/8500 and 8600 GVW and 3500 series).
Tighten the studs to 25 N.m (18 lb ft).
