Express 2500 V8-5.3L VIN T (2005)
Minor misalignment of the accessory drive pulley(s) will not cause excessive wear, but will probably cause the drive belt(s) to make a noise or fall off.
Excessive misalignment of the accessory drive pulley(s) will cause excessive wear and may also make the drive belt(s) fall off.
Test Description
The number(s) below refer to the step(s) in the diagnostic table.
2. This inspection is to verify that the drive belt(s) is correctly installed on all of the accessory drive pulleys. Wear on the drive belt(s) may be caused
by mis-positioning the drive belt(s) by one or more grooves on a pulley(s).
3. The installation of a drive belt(s) that is too wide or too narrow will cause wear on the drive belt(s). The drive belt(s) ribs should match all of the
grooves on the pulleys.
4. This inspection is to verify that the drive belt(s) is not contacting any part of the engine or body while the engine is operating. There should be
sufficient clearance when the accessory drive components load varies. The drive belt(s) should not come in contact with an engine or a body
component when snapping the throttle.
Drive Belt Falls Off
Drive Belt Falls Off Diagnosis
Diagnostic Aids
If the drive belt(s) repeatedly falls off the accessory drive pulley(s), this may be caused by a pulley misalignment.
An extra load that is quickly applied or released by an accessory drive component may also cause the drive belt(s) to fall off. Verify that the accessory