Express 2500 V8-5.3L VIN T (2005)
Air Bag: Service and Repair
Steering Wheel Module Replacement
INFLATABLE RESTRAINT STEERING WHEEL MODULE REPLACEMENT
REMOVAL PROCEDURE
1. Disable the inflatable restraint steering wheel module. Refer to SIR Disabling and Enabling Zone 3.
CAUTION:
-
Refer to SIR Inflator Module Handling and Storage Caution in Service Precautions.
-
Refer to SIR Caution in Service Precautions.
2. Using a blunt-ended tool, push the leaf spring fasteners (2) inward through the access holes. The access holes are located on both sides of the
steering wheel shroud.
3. Lift and partially remove the inflatable restraint steering wheel module from the steering wheel in order to expose the electrical connectors.
4. Disconnect the connector-position assurance (CPA) retainers from the electrical connectors.
5. Disconnect the electrical connectors from the inflatable restraint steering wheel module.
6. Remove the inflatable restraint module from the steering wheel.
IMPORTANT: Do not attempt to repair the inflatable restraint steering wheel module. The inflatable restraint steering wheel module is replaced only
as an assembly.
7. Fully deploy the module before disposal. If the module was replaced under warranty, fully deploy and dispose of the module after the required
retention period. Refer to Inflator Module Handling and Scrapping.
INSTALLATION PROCEDURE
1. Position the inflatable restraint module to the steering wheel.
2. Connect the electrical connectors to the inflatable restraint steering wheel module.
3. Connect the CPA retainers into the electrical connectors. Seat and lock the connections.
