Express 2500 V8-5.3L VIN T (2005)
5. Remove the connector position assurance (CPA) from the harness connector on the inflatable restraint I/P module.
6. Disconnect the I/P module electrical connector (1).
7. Remove the upper bolts (3) from the I/P module (1).
8. Remove the lower bolts (2) from the I/P module (1).
9. Remove the I/P module (1).
10. Ensure that the I/P module is fully deployed before disposal. If the module was replaced under warranty, fully deploy and dispose of the module
after the required retention period. Refer to Inflator Module Handling and Scrapping.
INSTALLATION PROCEDURE
1. Install the inflatable restraint I/P module (1) to the I/P carrier.
2. Install the lower bolts (2) hand tight.
NOTE: Refer to Fastener Notice in Service Precautions.
3. Install the lower bolts (3) to the inflatable restraint I/P module.
Tighten the bolts to 10 N.m (89 lb in).
