Express 2500 V8-5.3L VIN T (2005)
9. Remove the 2–4 servo assembly from the transmission.
10. Inspect the 4th apply piston, the 2–4 servo converter, 2nd apply piston, and the piston inner housing for the following defects:
^
Cracks
^
Scoring
^
Burrs and nicks
Installation Procedure
1. Install the new seals on the pistons and the servo cover.
2. Lubricate the seals with clean transmission fluid.
3. Install the 2-4 servo assembly into the 2-4 servo bore.
4. Install the servo cover and O-ring seal.
5. Install the J 29714-A .
6. Tighten the bolt on the J 29714-A in order to compress the servo cover.
7. Install the servo cover retaining ring.
8. Remove the J 29714-A from the oil pan flange.
9. Notice: Refer to Fastener Notice in Service Precautions.
Install the oil pan bolt.
^
Tighten the oil pan bolt to 11 Nm (97 inch lbs.).
10. Install the 2 heat shield retaining bolts and the heat shield from the transmission.
^
Tighten the bolts to 17 Nm (13 ft. lbs.).
11. Lower the vehicle.
12. Fill the transmission to the proper level with approved fluid.
