Express 2500 V8-6.6L DSL Turbo (2010)
Replace the passenger presence system as a complete assembly to prevent possible injury to the occupant. All the components in the service kit are
assembled and calibrated as a unit. Using only some of the components in the service kit will cause the passenger presence system to operate improperly.
6. If replacing the front passenger seat cushion pad, you must also replace the inflatable restraint passenger presence system. Refer to Inflatable
Restraint Passenger Presence System Replacement - Front (See: Restraint Systems/Air Bag Systems/Seat Occupant Sensor/Service and Repair).
Installation Procedure
1. Position the power seat switch bracket (2) to the seat cushion frame, if equipped.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
2. Install the screws (3) to retain the power seat switch bracket and tighten to 2 Nm (18 lb in).
3. Install the bolts (4) retaining the seat cushion frame to the adjuster.
4. Install the bolts (4) to retain the seat cushion frame to the adjuster and tighten to 25 Nm (18 lb ft).
5. Install the bolts (7) to retain the seat cushion frame.
6. Install the bolts (7) and tighten to 32 Nm (24 lb ft).
7. Install the seat cushion cover and pad. Refer to Front Seat Cushion Cover and Pad Replacement (See: Front Seat Cushion Cover and Pad