Express 2500 V8-6.6L DSL Turbo (2010)
6. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (See: Maintenance/Vehicle Lifting/Service and Repair).
7. Disconnect the front cable (2) from the intermediate cable (3).
8. Remove the cable from the frame bracket by depressing the retaining tabs.
9. Remove the cable.
Installation Procedure
1. Install the cable.
2. Snap the retainer tabs into the frame bracket.
3. Connect the front cable (2) to the intermediate cable (3).
4. Route the cable in through the floor pan and engage the grommet (1).
5. Remove the safety stands.
6. Lower the vehicle.
7. Install the cable anchor to the stud on the floor.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).