Express 2500 V8-6.6L DSL Turbo (2010)
17. Prior to removing the fuel injector pipes, use compressed air to blow any debris from between the injector line and fittings. Wipe the fittings clean
of debris.
18. Spray lithium grease between the fuel injector line and fittings to assist in containing any debris during removal. Refer to Adhesives, Fluids,
Lubricants, and Sealers (See: Specifications/Adhesives, Fluids, Lubricants, and Sealers).
Caution: DO NOT use compressed air to clean debris from the fuel injector inlet after the fuel line is removed. Using compressed air can allow
debris to enter the fuel injector inlet and damage the fuel injector.
19. Remove the left fuel injector pipes.
20. Remove No. 8 fuel injector bracket bolt.
21. Install the J-46594 into injector No. 8 bracket bolt hole.
22. Using the J-46594 pull injector No. 8 until it releases.
23. Remove the J-46594.
24. Remove No. 8 fuel injector and bracket.
25. Remove the upper valve rocker arm cover bolts.
