Express 2500 V8-6.6L DSL Turbo (2010)
1. Position the exhaust differential pressure sensor to the frame.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
2. Install the exhaust differential pressure sensor bracket bolt (2) and tighten to 9 Nm (80 lb in).
3. Install the exhaust differential pressure sensor pipe assembly hoses to the sensor.
4. Position the exhaust differential pressure sensor pipe assembly hose clamps (1).
5. Connect the engine wiring harness electrical connector (1) to the exhaust differential pressure sensor.
6. Lower the vehicle.