Express 2500 V8-6.6L DSL Turbo (2010)
3. Remove the lower mode actuator.
Installation Procedure
1. Install the lower mode actuator.
2. Press lower mode actuator on until you hear tabs engage.
3. Install the I/P carrier. Refer to Instrument Panel Carrier Replacement (See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument
Panel/Service and Repair/Instrument Panel Carrier Replacement).
Air Inlet Valve Actuator Replacement
Air Inlet Valve Actuator Replacement
Special Tools
J 39400-A Electronic Halogen Leak Detector
Removal Procedure
1. Remove the battery. Refer to Battery Replacement (Primary) (See: Starting and Charging/Battery/Service and Repair/Removal and Replacement
).
2. Recover the refrigerant from the A/C system. Refer to Refrigerant Recovery and Recharging (See: Service and Repair/Refrigerant Recovery and
Recharging).
3. Disconnect the low pressure sensor electrical connector.
4. Disconnect the blower motor electrical connector.
5. Disconnect the blower motor resistor assembly electrical connector.