Express 2500 V8-6.6L DSL Turbo (2010)
3. Connect the power steering cooler hose (2) to the steering gear (1) and tighten the fitting to 34 Nm (25 lb in).
4. From the left front wheel well, connect the power steering cooler hose (1) to the power steering pump (3) and secure with the hose clamp (2).
5. Install the left front tire and wheel assembly. Refer to Tire and Wheel Removal and Installation (See: Wheels and Tires/Service and Repair).
6. Lower the vehicle.
7. Fill and bleed the power steering system. Refer to Power Steering System Bleeding (See: Steering and Suspension/Steering/Power
Steering/Power Steering Bleeding/Service and Repair).
8. Clean any excess power steering fluid from the vehicle.
9. Remove the drain pans.
VIN 6
Power Steering Cooler Pipe/Hose Replacement (GT4 Without LGH)
Removal Procedure