Express 2500 V8-6.6L DSL Turbo (2010)
Wheel Fastener: Service and Repair
Rear Suspension
Wheel Stud Replacement
Tools Required
J 43631 Ball Joint Remover
Removal Procedure
1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (See: Vehicle Lifting/Service and Repair).
2. Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation (See: Service and Repair).
3. Remove the rotor. Refer to Rear Brake Rotor Replacement (JH5, JH6) (See: Brakes and Traction Control/Disc Brake System/Brake
Rotor/Disc/Service and Repair/Removal and Replacement/Rear Brake Rotor Replacement (JH5, JH6))Rear Brake Rotor Replacement (JH9) (
See: Brakes and Traction Control/Disc Brake System/Brake Rotor/Disc/Service and Repair/Removal and Replacement/Rear Brake Rotor
Replacement (JH9)).
4. Remove the wheel stud from the axle flange using the J 43631 for the 15 series.
5. Remove the axle shaft for vehicles with 9.5 inch ring gear. Refer to Rear Axle Shaft Replacement (See: Transmission and Drivetrain/Drive Axles,
Bearings and Joints/Axle Shaft Assembly/Axle Shaft/Service and Repair).
6. Remove the rear hub assembly for vehicles with 10.5 inch ring gear. Refer to Rear Axle Shaft Replacement (See: Transmission and
Drivetrain/Drive Axles, Bearings and Joints/Axle Shaft Assembly/Axle Shaft/Service and Repair).
7. Remove the wheel stud from the axle flange using the J 43631.
8. Remove the wheel stud from the hub flange using the J 43631.
Installation Procedure
1. Install the stud into the axle flange for the 15 series.
2. Install the 4 washers and the lug nut to the stud.
3. Tighten the lug nut in order to draw the stud into the flange until the stud fully seats.
4. Remove the lug nut and the washers.
5. Install the axle shaft for the vehicles with 9.5 inch ring gear. Refer to Rear Axle Shaft Replacement (See: Transmission and Drivetrain/Drive
Axles, Bearings and Joints/Axle Shaft Assembly/Axle Shaft/Service and Repair).
6. Install the rear hub assembly for the vehicles with 10.5 inch ring gear. Refer to Rear Axle Shaft Replacement (See: Transmission and
Drivetrain/Drive Axles, Bearings and Joints/Axle Shaft Assembly/Axle Shaft/Service and Repair).
7. Install the rotor. Refer to Rear Brake Rotor Replacement (JH5, JH6) (See: Brakes and Traction Control/Disc Brake System/Brake
Rotor/Disc/Service and Repair/Removal and Replacement/Rear Brake Rotor Replacement (JH5, JH6))Rear Brake Rotor Replacement (JH9) (
See: Brakes and Traction Control/Disc Brake System/Brake Rotor/Disc/Service and Repair/Removal and Replacement/Rear Brake Rotor