Express 2500 V8-6.6L DSL Turbo (2010)
Note: The crankshaft reluctor and the oil pump drive gear are timed at the factory. In order to re-establish proper timing, install knock pins in the
oil pump drive gear if the crankshaft reluctor was removed from the oil pump drive gear. The knock pins are available through the parts
department.
1. Install the knock pins in the oil pump drive gear to a height of 4.5-5.5 mm (0.177-0.217 in)
2. Install the crankshaft reluctor on the oil pump drive gear. Ensure the reluctor is aligned on the knock pins.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
3. Install the crankshaft reluctor bolts and tighten to 8 Nm (71 lb in).
