Express 2500 V8-6.6L DSL Turbo (2010)
1. Remove the sending unit. Refer to Fuel Sender Assembly Replacement (See: Sensors and Switches - Instrument Panel/Fuel Gauge
Sender/Service and Repair).
2. Disconnect the fuel level sensor electrical connector (1).
3. Remove the sensor retaining clip (3).
4. Squeeze the locking tangs (2) and remove the fuel level sensor.
Installation Procedure
1. Install the fuel level sensor.
2. Install the sensor retaining clip (3).
3. Connect the sensor electrical connector (1).
4. Install the sending unit. Refer to Fuel Sender Assembly Replacement (See: Sensors and Switches - Instrument Panel/Fuel Gauge Sender/Service
and Repair).