Express 2500 V8-6.6L DSL Turbo (2010)
6. Disconnect the power brake booster inlet hose (1) from the power brake booster (2).
7. Remove the power brake booster inlet hose from the vehicle.
Installation Procedure
Caution: Refer to Installing Hoses without Twists or Bends Caution (See: Service Precautions/Vehicle Damage Warnings/Installing Hoses
without Twists or Bends Caution).
1. Position the power brake booster inlet hose (1) in the vehicle.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
2. Connect the power brake booster inlet hose to the power brake booster (2). Hand tighten the fitting.
3. Raise the vehicle.
4. From the left front wheel well, connect the power brake booster inlet hose (2) to the power steering pump (1). Tighten the hose fitting to 34 Nm
(25 lb ft).
5. Lower the vehicle.
6. Tighten the power brake booster inlet hose fitting on the power brake booster to 34 Nm (25 lb ft).
7. Fill and bleed the power steering system. Refer to Power Steering System Bleeding (See: Power Steering Bleeding/Service and Repair).
8. Clean any excess power steering fluid from the vehicle.
9. Remove the drain pans from under the vehicle.
