Express 2500 V8-6.6L DSL Turbo (2010)
11. Remove the retaining ring (1) from the slip yoke (3).
12. Using the J-9522-3 - Separator, J-9522-5 - Remover and a press, remove the universal bearing (2) from the yoke (3).
13. Remove the spider (2) from the slip yoke (1).
14. Thoroughly clean the slip yoke and the propeller shaft yoke of any contaminates that could prevent the retaining rings or the bearing cups from
being properly installed.
Installation Procedure
Note: If replacing the propeller shaft slip yoke, proceed to step 8.