Express 2500 V8-6.6L DSL Turbo (2010)
Note: If the wheel hub assembly does not fully seat itself onto the axle shaft spindle and is removed, the wheel hub seal must be replaced.
12. Install the wheel hub to the axle housing.
13. Using the J 2222-C - wrench, install the adjusting nut to the hub.
14. Adjust the wheel bearings. Refer to Wheel Bearing Adjustment (See: Differential Assembly/Service and Repair/Procedures/Wheel Bearing
Adjustment).
15. Install the axle shaft. Refer to Rear Axle Shaft and/or Gasket Replacement (See: Rear Axle Shaft and/or Gasket Replacement).
16. Install the brake caliper bracket. Refer to Rear Brake Caliper Bracket Replacement (JH5, JH6) (See: Brakes and Traction Control/Disc Brake
System/Brake Caliper/Service and Repair/Removal and Replacement/Rear Brake Caliper Bracket Replacement (JH5, JH6))Rear Brake Caliper
Bracket Replacement (JH9) (See: Brakes and Traction Control/Disc Brake System/Brake Caliper/Service and Repair/Removal and
Replacement/Rear Brake Caliper Bracket Replacement (JH9)).
17. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation (See: Maintenance/Wheels and Tires/Service and Repair).
18. Inspect and add axle lubricant to the axle housing, if necessary. Refer to Rear Axle Lubricant Level Inspection (8.6, 9.5 LD Axle) (See:
Differential Assembly/Fluid - Differential/Service and Repair/Procedures/Rear Axle Lubricant Level Inspection (8.6, 9.5 LD Axle))Rear Axle
Lubricant Level Inspection (10.5 Inch Axle) (See: Differential Assembly/Fluid - Differential/Service and Repair/Procedures/Rear Axle Lubricant
Level Inspection (10.5 Inch Axle)).
19. Lower the vehicle.
