Express 2500 V8-6.6L DSL Turbo VIN 2 (2007)
10. Position the engine wiring harness bracket (1), install the engine wiring harness to bracket bolt and the 2 engine wiring harness bracket to upper
valve cover bolts.
Tighten the bolts to 21 N.m (15 lb ft).
11. Connect the left engine wiring main harness connector.
12. Install the fuel feed/return line bracket and bolt located under glow plug module bracket.
13. Install the injector/glow plug wire harness retaining bolt at the lower part of the upper valve cover.
14. Install the glow plug module and bracket.
15. If equipped, install the auxiliary generator. Refer to Auxiliary Generator Replacement .
16. Install the upper fan shroud.
17. If the fuel injectors were replaced, Refer to Fuel Injector Flow Rate Programming. See: Testing and Inspection/Programming and Relearning
18. Prime the fuel system. Refer to Fuel System Priming.
19. Start the engine. If the engine stalls, repeat the above step.
20. Once the engine starts, inspect for fuel leaks.
