Express 2500 V8-6.6L DSL Turbo VIN 2 (2007)
Fuel Supply Line: Service and Repair
Fuel Feed Pipe and Return Pipe Purging
Fuel Feed Pipe and Return Pipe Purging
1. Pump the primer located on top of the fuel filter 30 times or until stiff.
2. Attempt to start and run the engine. If the engine does not start, repeat step 1.
3. Allow to run for 5 minutes at idle.
4. Check for fuel leaks.
5. Clear all engine diagnostic trouble codes (DTCs).
Fuel Feed Pipe Replacement
Fuel Feed Pipe Replacement
Tools Required
*
J 43178 Fuel Line Disconnect Tool
*
J 44581 Fuel Line Disconnect Tool
Removal Procedure
1. Remove the engine cover.
2. Remove the charge air cooler inlet pipe.
3. Remove the center intake manifold.
4. Using the J 43178 and J 44581 disconnect the fuel feed and return pipes.