Express 2500 V8-6.6L DSL Turbo VIN 2 (2007)
Glow Plug Control Module: Service and Repair
Glow Plug Control Module Replacement
Removal Procedure
1. Disconnect the negative battery cable.
2. Remove the engine cover.
3. Remove the charged air cooler inlet hose/pipe assembly.
4. Disconnect the glow plug control module electrical connectors.
5. Disconnect the positive battery cable from the glow plug control module.
6. Remove the glow plug control module bolts.
7. Remove the glow plug control module.
8. Remove the glow plug control module bracket bolts, if required.
9. Remove the glow plug control module bracket, if required.
Installation Procedure
1. Install the glow plug control module bracket, if required.
Notice: Refer to Fastener Notice.
2. Install the glow plug control module bracket bolts, if required.
Tighten the bolts to 10 N.m (89 lb in).
