Express 2500 V8-6.6L DSL Turbo VIN 2 (2007)
*
J 38826-75 Steering wheel module adapter
*
J 38826-80 I/P module adapter
1. Turn OFF the ignition.
2. Remove the ignition key.
3. Put on safety glasses.
4. Remove the inflator module.
*
When removing the steering wheel module, refer to Inflatable Restraint Steering Wheel Module Replacement.
*
When removing the I/P module, refer to Inflatable Restraint Instrument Panel Module Replacement.
5. Place the inflator module with the vinyl trim cover facing up and away from the surface on a work bench, floor or deployment fixture.
6. Clear an area on the floor approximately 1.85 m (6 ft) in diameter for deployment of the inflator module. If possible, use a paved, outdoor
location free of activity. Otherwise, use an area free of activity on the shop floor. Make sure you have sufficient ventilation.
7. Make sure no loose or flammable objects are in the area.
Important: Dual stage deployments are only used in steering wheel and I/P inflator modules. If stage 1 was used to deploy the inflator
module, stage 2 may still be active. If disposal of a deployed or undeployed dual stage module is required, both deployment loops must be
energized to deploy the air bag.
8. When deploying a steering wheel module, place the steering wheel module in the center of the cleared area.
9. When deploying an I/P module, refer to the following instructions:
*
Place the J 39401-B (2) in the center of the cleared area.
*
Fill the deployment fixture (2) with water or sand.
*
Mount the I/P module (1) in the deployment fixture (2) with the vinyl/plastic trim facing up.
*
To mount, use 4 M 6 bolts (6), nuts (8), and washers (7) to properly secure the I/P module (1) to the deployment fixture (2).
*
Tighten all fasteners prior to deployment.
