Express 2500 V8-6.6L DSL Turbo VIN 2 (2007)
6. Wrap the tie strap around the necked porting of the sensor body just above the hex. Insert the end of the strap in the buckle and tighten by pulling
the end with needlenose pliers.
7. Bend the end of the tie strap 180 degrees over the top of the buckle.
8. Cut off the tie strap using side cutters so that the cut end will lie approximately over the center of the buckle. Push down the end of the tie strap
over the buckle in order to minimize protrusion of the cut end or any sharp edges.
