Express 2500 V8-6.6L DSL Turbo VIN 2 (2007)
1. Carefully slide a new selector shaft seal (1) over the selector shaft (2) with the wide face of the steel case facing outward. Position the seal so that
it is starting to enter the seal bore.
2. Obtain J 43909 and remove the inner sleeve so that the tool will slide over the selector shaft.
3. Slide the J 43909 into position so that the end of the tool contacts the seal being installed. Use a mallet to strike the J 43909 and drive the new seal
into the seal bore until it is seated at the bottom of the bore.
4. Install the PNP Switch.
5. Lower the vehicle.
6. Fill the transmission to the proper level with DEXRON(R) VI transmission fluid. Refer to Transmission Fluid Check .
Transmission Extension Housing Rear Oil Seal Replacement
Transmission Extension Housing Rear Oil Seal Replacement
Tools Required
*
J 21426 Extension Housing Seal Installer
*
J 36850 Transjel Lubricant
Removal Procedure
1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
2. Place a drain pan under the vehicle.
3. Remove the propeller shaft.
4. Remove the case extension housing rear oil seal. Use a flat-bladed tool and carefully pry the seal from the housing.
5. Inspect the case extension housing for damage.
Installation Procedure
1. Lubricate the inside diameter of the new seal with J 36850 .
2. Use the J 21426 with a soft faced mallet to install the seal.
3. Install the seal to the extension housing.
4. Install the propeller shaft.
5. Remove the drain pan and lower the vehicle.
6. Fill the transmission to the proper level with DEXRON(R) VI transmission fluid. Refer to Transmission Fluid Check .
