Express 3/4 Ton Van V8-305 5.0L VIN M SFI (1999)
^
Tighten the three Allen bolts to 8 Nm (6 ft. lbs.), then to 16 Nm (12 ft. lbs.).
4. Install the new EBCM gasket (3) onto the BPMV (4).
^
Insure gasket alignment is correct.
5. Install EBCM (2) onto BPMV (4).
6. Install the four new EBCM bolts (1).
^
Tighten the four bolts to 5 Nm (39 inch lbs.) in an X-pattern.
7. Install BPMV (4) to bracket.
8. Install the three BPMV (4) to bracket retaining bolts.
^
Tighten the three bolts to 9 Nm (7 ft. lbs.).
9. Install the Electro-Hydraulic Control Unit (EHCU) to the vehicle frame.
^
Tighten the three bolts to 12 Nm (9 ft. lbs.).
10. Install the right front, left front and rear brake pipes to the tube adapters.
^
Tighten the front brake pipe fittings to 20 Nm (16 ft. lbs.).
^
Tighten the rear brake pipe fitting to 30 Nm (22 ft. lbs.).
11. Install the front and rear brake pipes (from master cylinder) to the combination valve.
^
Tighten the three brake pipe fittings to 30 Nm (22 ft. lbs.).
12. Connect the electrical connector to the combination valve.
13. Connect the four electrical connectors to the EBCM.
14. Install the EHCU Shield.
^
Tighten the three bolts to 12 Nm (8 ft. lbs.).
15. Lower the vehicle
16. Connect the negative battery cable.
17. Bleed the brake system.
IMPORTANT: Verify that the combination valve metering rod is depressed during bleeding.
18. Return to Diagnostic System Check.
