chevrolet Workshop Repair Guides

Chevrolet Workshop Service and Repair Manuals

Panel Replacement|Page 10175 > < Panel Replacement|Page 10173
Page 3
background image

1. Remove the side door pull handle screws (3).
2. Remove the side door pull handle (2).
3. Use the J 38778  to disengage the retainers around the outside edges of the lower portion of the door trim panel (1).
4. Carefully pull the door trim panel (1) out of the retainers around the window opening.

A long flat bladed tool may be necessary to aid in releasing the door trim panel (1) from the window opening retainers.

5. Remove the front door panel (1) from the vehicle.

Installation Procedure

1. Install the door trim panel (1) to the door by performing the following:

*

Align the door trim panel (1) to the retainers in the window opening.

*

Push towards the door to engage the retainers.

*

Align the retainers on the edges of the lower portion of the door trim (1).

*

Push towards the door to engage the retainers.

Notice:  Refer to Fastener Notice  in Cautions and Notices.

2. Install the pull handle (2) and screws (2).

Tighten the screws (3) to 1.9 N.m (17 lb in).

Trim Panel Replacement - Side Rear Door - 60/40 Left (E26, 60 Door)

Trim Panel Replacement - Side Rear Door - 60/40 Left (E26, 60 door)

Tools Required

Panel Replacement|Page 10175 > < Panel Replacement|Page 10173