Express 3/4 Ton Van V8-4.8L VIN V (2003)
Rear Sliding Door Index
Condition 1
The sliding door may be misaligned, not flush with the rear quarter panel or front door.
Cause
There may be several causes for a misaligned sliding door which are listed below:
If the door is tilted forward and down or up and back, the front lower roller may be out of adjustment.
If the door is inboard or outboard at the top front corner or lower rear corner, the top roller may out of adjustment.
If the door is too far forward or rearward and the gaps are parallel, the center roller may be out of adjustment.
If the rear door is too far in or out at the rear quarter panel, the rear striker may be out of adjustment.
If the door is too far in or out at the front door area, the front striker may be out of adjustment.
Correction
The original position of the component being adjusted should be marked prior to adjusting. This may help reference the beginning point and show how
much adjustment was made.
Inspect/Adjust the door strikers, door wedge guide and rollers as needed.
